Product Advantage :
Tearing resistance & wear-resisting
Anti-folding and fast bouncing back
Elongation at break up to 135%
Non VOC, RoHS Reach EN71-3 certificated
Compatible for most 3D printer
Technical specification：
| Viscosity：550-750MPa·s | Hardness(Shore A)：40-45A |
| Tensile strength：0.66 ±10% MPa | Elongation at break：135.58±10% |
| Tensile modulus：0.59±10% MPa | Density：1.05—1.25 g/cm3 |
| Maximum pulling force: 27.44 N ±10% |
Printing parameter:
ELA series are perfectly on most brand LCD printer, and fast printing on DLPs.
For LCD printer, bottom layer 20-70s and each layer exposure time 4-20s, for example, layer thickness 50 micron on Anycubic printer, base 35s while each layer 18s.
For DLP printer, bottom 5-15s and each layer 3-8s.
The exposure time should be adjusted according to printer light energy, layer thickness and model structure.
Cleaning and post-curing
- For Regular resin:
- Step1, Spray with Isopropanol, then blow resin away with cool wind.
- Step2, Prepare two containers with Isopropanol (alcohol> 95%), and place the jobs into the first container and slightly shake it, then soak in the second container for about 1 minute (dental resin should not exceed 30 seconds).
- Step3, Flush with water before dry it, do make it sure it ‘s 100% dried as residuary alcohol may cause white spot or crack on jobs.
- For high wax resin (cwic ewic):
- Step 1, keep the prints on the flatform, and wipe away the resin on the flatform with tissue.
- Step2, Spray the alcohol on the prints and blow it with cool air.
- Step3, Repeat it until it is clean.
Note: Do not dip in alcohol too long as it may crack and with white spot.
- Water washable resin:
Cleaning with flush water and brush it gently with a soft brush, and then drying it with cold air.
Note:
- Do not use ultrasonic for cleaning, especially for casting resin.
- Dental resin jobs are recommended to be cleaned before takeoff from the platform to avoid deformation.
Post-curing:
- The curing time is proportional to the volume of the work piece and inversely proportional to the optical power of the curing chamber. Example: 100 watt LED curing box, jewelry jobs is recommended to be cured with soaking in water for 20-30 minutes.
- The post-cure time of dental casting resin, dental non-casting resin and jewelry mold resin shall not more than 5 minutes.
- Work-pieces should be in the water during post-curing to prevent deformation especially for dental and jewelry.
- Don’t forget to use cool air to dry it after post-curing.
Warning：
- This material should not be in contact with eyes, skin or clothing, and should not be tasted or eaten.
- If you accidentally touch your eyes or skin, immediately rinse with water for about 20 minutes and seek medical advice if necessary.
- Please pay attention to air circulation and take protective measures when using. Wash thoroughly after handling.
- The product is in a liquid state with a slight odor. Wear a mask and gloves.
- The product should be stored in a sealed container. After use, it should be filtered and keep back in bottle on time and placed in a dry and well ventilated place. It should not be exposed to sunlight.
- Shake well before use, and leave it for 30 minutes to eliminate air bubbles that generated during the shaking process.
- The ambient temperature is recommended to be controlled at 25-30 degrees Celsius, and during the printing should avoid any lights.
- Dispose of waste in accordance with local environmental regulations.
- Storage environment: Store in cool and dry place, and avoid sunlight, recommended temperature at 25-30 degrees Celsius.
